There's more ! I was able to open the saved block for editing in a new window, choose Rotate from the top tool bar under Modify, then choose Select All from the Select menu on the top tool bar. That new block then appeared in the block list, only when I then saved the drawing, closed it, and then reopened it. I created a block from my nineteen entities with the protocol that appears under the Block menu item in the upper toolbar, selecting each of the nineteen items by clicking on each one and then pressing Enter, after which I was prompted to select a reference point, followed by another Enter, followed by the prompt to choose a name. Therefore, after you have selected part(s) of your drawing, not only must you create the block so that you are given the opportunity to name it, but you must also save the associated drawing, or that block will disappear forever. Only new blocks that are created in the associated drawing are shown with that drawing. The defaults blocks are outlines of a standard drawing with the usual legend where one would list all the scales, changes, etc. There is a list of blocks for each drawing, which one can find by activating the Layer list and Block list from the View menu list in the top toolbar. Once that is done and I have successfully saved the block, my plan is to copy it and paste it into my drawing after rotating the entire block by 180 degrees. Which one will produce my intended block ? but I have progressed no further with that approach. There is a set of block icons in the menu bar that lies along the left side of the screen, within which I can activate the Select window and then define my block by sweeping the cursor with the mouse from upper left to lower right, whereupon every one of the nineteen entities that I have drawn, along with their text elements, show that they have been selected. When I select "save block" I am told that no block has been activated to save, but all the nineteen entities are indicated as selected, but not their associated text.Ģ. There is a Block item in the top menu line, and when I select "create block" I am allowed to select each item separately of the nineteen than I have drawn, select a reference point, and when I press "Enter" I am prompted to enter a name. There appear to be two ways of creating a block, but neither is intuitive.ġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |